Fujitsu PRIMERGY RX600 S4 Operating Manual page 40

Rack installation/removal of server
DataCenter Rack
– Directly laterally bolted telescopic rails or sliding rails (except within the rear
left area where a support bracket is used).
– Enhanced cable management in the lateral rack area.
The mounting of the rails in the different racks is described in the next sections.
Installation of the cable management is described in detail in the Technical
Manual for the respective rack.
For rack systems from other manufacturers:
3rd party rack
Certain general conditions must be met:
– Installation dimensions (see also figure
1 Front of rack
2 Rear of rack
A Rack depth (comparison PRIMECENTER Rack 940/1000/1100 mm)
B Rack width (comparison PRIMECENTER Rack 700 mm)
C Clearance for 19" installation level
C1 Front 19" installation level
C2 Rear 19" installation level
D Cable routing area (cable area depth) and ventilation
E Space for front panel and ventilation
F Space for right and left support systems
P PRIMERGY rack installation depth
a1 Front left support upright
a2 Front right support upright
b1 Rear left support upright
b2 Rear right support upright
40
2 on page
Operating manual
Hardware installation
41):
RX600 S4