Switching The Server On And Off - Fujitsu PRIMERGY RX600 S4 Operating Manual

Starting up and operation
5.2

Switching the server on and off

V
CAUTION!
It nothing appears on the screen but flickering stripes after switching on
the server, switch the server off immediately (see chapter
shooting and tips" on page
The On/Off button does not disconnect the server from the mains. To
completely disconnect it from the mains voltage, remove the power plugs
from the sockets.
Switching the server on
The power-on indicator at the front does not light up (item 6 in figure
page 55). The power indicator on the power supply units lights up if the server
is connected to the mains (item 3 in figure
– Starting up for the first time:
Ê Press the On/Off button (item 9 in figure
Power-on indicator lights up green.
Ê Insert ServerStart disc 1 in the DVD drive.
Ê Follow the on-screen instructions (see also section
ServerStart" on page 70
on page 71).
– System already installed:
Ê Press the On/Off button (item 9 in figure
Power-on indicator lights up green.
The server is switched on, performs a system test and boots the
operating system.
RX600 S4
Switching the server on and off
75).
21 on page
13 on page
or section "Configuration without ServerStart"
13 on page
Operating manual
"Trouble-
13 on
66).
55).
"Configuration with
55).
67