Installing/Removing A Hdd/Dummy Module - Fujitsu PRIMERGY RX100 S3 Operating Manual

Hot-plug Hard Disk Drives
8.2

Installing/Removing a HDD/Dummy Module

Removing the dummy module
Free slots are provided with a dummy module (an empty carrier) which must be
removed before installing an additional HDD module.
Figure 11: Removing the dummy module (hot-plug variant only)
Ê Press both tabs on the dummy module together (see
locking mechanism disengages, and remove the dummy module from the
slot.
Installation of the dummy module occurs in reverse order.
V
CAUTION!
Keep the dummy module for future use. If the HDD module is removed
again and is not replaced with a new module, then the dummy module
must be reinstalled due to cooling, the applicable EMC (electromagnetic
compatibility) regulations and fire protection.
U41615-J-Z156-1-76
Installing/Removing a HDD/Dummy Module
figure 11) until the
59