Removing / Installing A Memory Dummy Module - Fujitsu PRIMERGY CX122 S1 Service Supplement Manual

Installing / replacing memory modules
4.6.3

Removing / installing a memory dummy module

V
CAUTION!
In order to satisfy cooling
requirements, please note:
When removing a memory
module that is not replaced
immediately, always install a
memory dummy module in
the empty memory slot!
Removing a memory dummy module
Figure 55: Removing a memory dummy module
Ê Eject the memory dummy module by pressing out the securing clips at each
end of the memory module connector.
Installing a memory dummy module
Ê Lower the memory dummy module into the memory slot.
Ê Press down on the memory dummy module until the securing clips snap into
the cutouts at each end of the module.
76 Service Supplement
PRIMERGY CX122 S1