Table of Contents
Advertisement
Configuration Wizard
3
Configuration Wizard
This chapter describes how to access the built-in Configuration tool and run
the Configuration Wizard in order to perform the initial configuration.
Note:
3.1
Introduction
The HM490dp is an advanced ADSL router with several features and
supported modes that make it ideal for advanced home networking. The
HM490dp offers a Configuration Wizard that enables you to easily
configure the HM490dp through a user friendly GUI. No special software is
required on your PC to manage and operate the HM490dp. All you need is
a web browser.
In the Configuration Wizard you can just select an Internet Access mode
that fits your needs according to information from your ISP.
The HM490dp still offers the possibility for advanced users to set up special
network scenarios themselves or to modify the existing ones. Refer to
chapter 5 - "Advanced Setup" for further information.
3.2
Access the Configuration Wizard
Follow the steps below to access the built-in Configuration tool and start the
Configuration Wizard.
Note:
1
10
The first time you access the Configuration tool, this has to be done
from a client PC connected to one of the Ethernet ports as the
Wireless LAN interface is disabled by default.
Before performing the following steps make sure that all the steps
in section 2.4 - "Installation" has been performed.
Start your web browser and type http://192.168.1.1 (the IP address for
the HM490dp) in the URL field and hit Enter.
1553-ZAT 759 95 Uen C – June 2005
Advertisement
Table of Contents
