Table of Contents
Advertisement
Configure PCs
6
Configure PCs
This chapter provides instructions for configuring the Internet settings on
your computers to work with the HM490dp.
6.1
Before You Begin
By default, the HM490dp automatically assigns the required Internet
settings to your PCs. You need only to configure the PCs to accept the
information when it is assigned.
Note:
If you have connected your LAN PCs via Ethernet to the HM490dp, follow
the instructions that correspond to the operating system installed on your
PC in the following sub-sections.
If you want to allow Wireless PCs to access your device, follow the
instructions in section 6.3 – "Configure Wireless PCs".
6.2
Configure Ethernet PCs
6.2.1
Obtain Internet Information Automatically
Follow the instructions that correspond to the operating system installed on
your PC.
6.2.1.1
Windows XP
1
2
3
1553-ZAT 759 95 Uen C – July 2005
In some cases, you may want to assign Internet information
manually to some or all of your computers rather than allow the
HM490dp to do so. See section 6.2.2 – "Assign Static Internet
Information".
In the Windows task bar, click the Start button, and then click Control
Panel.
Double-click on the Network Connections icon.
In the LAN or High-Speed Internet window, right-click on the icon
corresponding to your network interface card (NIC) and click the
button. (Often, this icon is labeled Local Area Connection).
Properties
81
Advertisement
Table of Contents
