Table of Contents
Advertisement
Configuration Wizard
3
Configuration Wizard
This chapter describes how to access the built-in Configuration tool and run
the Configuration Wizard in order to perform the initial configuration.
3.1
Introduction
The HM410dp is an advanced ADSL router with several features and
supported modes that make it ideal for advanced home networking. The
HM410dp offers a Configuration Wizard that enables you to easily
configure the HM410dp through a user friendly GUI. No special software is
required on your PC to manage and operate the HM410dp. All you need is
a web browser.
In the Configuration Wizard you can just select an Internet Access mode
that fits your needs according to information from your ISP.
The HM410dp still offers the possibility for advanced users to set up special
network scenarios themselves or to modify the existing ones. Refer to
chapter 5 - "Advanced Setup" for further information.
3.2
Access the Configuration Wizard
Follow the steps below to access the built-in Configuration tool and start the
Configuration Wizard.
Note:
1
2
8
Before performing the following steps make sure that all the steps
in section 2.4 - "Installation" has been performed.
Start your web browser and type http://192.168.1.1 (the IP address for
the HM410dp) in the URL field and hit Enter.
To access the Configuration tool you have to login and the following
window is displayed:
1553-ZAT 759 94 Uen B – July 2005
Advertisement
Table of Contents
