Ericsson HM490dp User Manual page 83

Advanced Setup
1
2
Note:
5.10.1.1 Reset Button
You can also reset the HM490dp to factory default settings using the Reset
button (tiny hole) on the back panel of the unit. This method is used if you
are unable to access the configuration pages.
To reset the HM490dp using the Reset button, follow the steps below:
1
2
1553-ZAT 759 95 Uen C – July 2005
The Default Settings page reminds you that the resetting to factory
defaults cannot be undone – any changes that you have made to the
basic settings will be lost.
If you are happy with this, click in the "Confirm" box to tick it and then
click the
Reset to Defaults
Once the reset is complete, the Start page is displayed.
Resetting to defaults also resets the username and password to
their default settings. If you have previously changed the username
and password the "Connect to ..." or "Enter Current Password"
login box will be displayed.
Once you have entered the default settings (admin, admin) and
clicked , the Start page is displayed.
OK
Power off the unit.
By using the tip of a pen press the Reset button and power on the unit.
Keep the button pressed for at least twenty (20) seconds.
button. The following page is displayed:
77