Table of Contents
Advertisement
Configuration Wizard
4
3.2.4
PPPoE
The PPPoE (or dial-up) access mode is used by the ISP to identify users
and allow them access to the Internet. You have to enter a valid Username
and Password provided by your ISP. Once you have entered your
Username and Password within the Wizard, the HM490dp will automatically
connect to your ISP whenever you use your Internet connection.
The "On-Line Time" column on the Welcome page indicates the time you
have been online and when the connection is disconnected the counter will
stop and be reset.
The HM490dp automatically activates the NAT service that will route the
traffic to/from the WAN and its internal DHCP server that will assign private
IP addresses to the PCs on the LAN/WLAN.
Note:
To configure the HM490dp for PPPoE access mode, follow the steps
below:
1
2
16
No further settings for Internet Access have to be done and the next
page in the wizard is Wireless Network: Set Country. Continue to
section 3.2.9 – "Wireless Network Settings" to proceed.
If you already have PPPoE client software installed on your
computer(s), you must uninstall it. This can be done after
completing this wizard.
From the Start page, click the
the following page:
Select PPPoE and click the
appears:
Configuration Wizard >
button. The following page
Next>
1553-ZAT 759 95 Uen C – June 2005
button to display
Advertisement
Table of Contents
