Table of Contents
Advertisement
20.0 Domestic Dialling
Domestic dialling enables the control panel to call
your mobile phone or a relative or friend if the
system detects an alarm. You can program up to
three different telephone numbers to call when an
alarm occurs. Although only your installer can set the
system to report in the domestic format, the Master
Code holder can change the domestic telephone
numbers at any time.
20.1
Acknowledging Domestic Calls
If an alarm occurs, the system calls the first
programmed telephone number. When you answer
an incoming call, the system sounds a repeating siren
tone followed by a pause, continuously for 2 min (for
example, siren tone, pause, siren tone, and pause).
If you do not acknowledge the call from the control
panel during a pause between siren tones, the control
panel hangs up after 2 min, and calls the next
telephone number.
Press [*] for 1 to 3 sec during the pause to
acknowledge the call.
If you acknowledge the call, the control panel does
not call any more phone numbers for that event. If
the call is successfully acknowledged, a tone of
decreasing pitch sounds.
Table 11: Domestic Dialling Telephone Digits
Digit
Number to
Required
Program
0
0
1
1
2
2
3
3
4
4
5
5
6
6
7
7
20.2
Programming Domestic Telephone
Numbers
If your system is configured for domestic dialling, the
Master Code holder can program the telephone
numbers the control panel calls if an alarm occurs.
Bosch Security Systems | 7/05 | F01U009494B
Digit
Number to
Required
Program
8
8
9
9
*
*1
#
*2
4-sec pause
*3
break
*4
CC404 | Operators Guide | 20.0
To program telephone numbers:
1. Enter your four-character Master Code and press
[2 #] (for example, [2 5 8 0 2 #]).
Three beeps sound and the STAY and AWAY
indicators flash.
If there are telephone numbers already
programmed, the numbers appear one digit at a
time by the codepad indicators.
If there are no telephone numbers programmed,
another two beeps sound after entering this
mode. These two beeps are normally heard after
the last digit of the last telephone number
appears.
2. Enter the first telephone number (for example,
[9 6 7 2 1 7 1 7]).
As you enter each digit, the corresponding
codepad indicators light.
3. To program another telephone number, press
[* 4] and repeat Step 2.
This inserts a break between the first telephone
number and the second telephone number.
4. Press [#] to exit this function.
20.3
Disable Domestic Dialling
To suspend domestic dialling (for example, you are
moving and do not want the system to continue
calling your mobile phone):
1. Enter your four-character Master Code and press
[2 #] (for example, [2 5 8 0 2 #]).
Two beeps sound and the STAY and AWAY
indicators flash.
2. Press [* 4 #].
The STAY and AWAY indicators turn off.
Domestic Dialling
15
Advertisement
Table of Contents
