Table of Contents
Advertisement
Security System
User Guide
Auto-Forward On/Off (Cmd 82)
I can perform this command.
I cannot perform this command.
Use this command to turn the auto-forward feature on or off as necessary.
1.
Press [CMD] [8] [2]. The command center may prompt you to enter a valid passcode.
2.
Enter your passcode if necessary. The command center displays the current status and the available options.
Program the Auto-Forward feature by pressing [1] to turn Auto-Forward On, or [2] to turn Auto-Forward
Off. For example, if Auto-Forward is On, press [2] to turn it Off.
3.
To exit this function, press [CMD].
Remote Arming with Telephone, Area 1
I can perform this command.
I cannot perform this command.
This function controls the built-in telephone arming feature for Area 1. When enabled, the panel answers the phone on the
programmed ring count.
When the panel answers the phone, it
• Sounds three beeps and starts the handshake tone for remote programming if the panel is All or Part On.
• Sounds one short beep, waits approximately 3 sec., and then sounds one long beep if the panel is Off. Press and
hold the [5] key* for 2 sec. immediately after the first short arming beep and before the long beep begins.
• Arms if it detects a [5] key press from the telephone (All On with Delay, faulted points are force-armed). The
panel sounds three beeps (new armed state) and then hangs up.
* If arming from a cell phone, quickly press the [5] key three times. If pressing and holding the [5] key for 2 sec. from a
house (land line) phone does not produce a tone long enough to arm Area 1, retry by quickly pressing the [5] key three
times.
Remotely disarming the panel cannot be done with a telephone.
IMPORTANT
46841D
D623/D625 User Guide
Page 40
© 2003 Bosch Security Systems
Advertisement
Table of Contents
