Fuel System; Checking Engine Oil Level; Maintenance - Arctic Cat ZR 3000 Operator's Manual

The longevity and safety of the snowmobile
can be increased by making periodic checks
of the items in the preceding checklist.
If, at any time, abnormal noises, vibrations,
or improper working conditions of any com-
ponent of this snowmobile are detected, DO
NOT OPERATE THE SNOWMOBILE.
Take the snowmobile to an authorized Arc-
tic Cat Snowmobile dealer for inspection
and adjustment or repair. If not under war-
ranty, this service is at the discretion and
expense of the snowmobile owner.
The snowmobile should be taken to an
authorized Arctic Cat Snowmobile dealer at
the end of each snowmobiling season for
general inspection and for off-season stor-
age servicing. This inspection and servicing
is at the expense of the snowmobile owner.

Fuel System

! WARNING
Whenever any
inspection is made on the fuel system
in which there may be fuel leakage,
there should be no welding, smoking,
open flames, etc., in the area.
Gasoline Additives
Fuel de-icer can be used for all models.
Arctic Cat Fuel Stabilizer (p/n 0436-907)
should also be added to the last tank of
gasoline before storage.
Fuel Pickup Valves
These models are equipped with fuel
pickup valves in the gas tank. If ever there
is a restricted fuel flow and a pickup valve
is suspected, take the snowmobile to an
authorized Arctic Cat Snowmobile dealer
for this service. If not under warranty, this
service is at the discretion and expense of
the snowmobile owner.
26

maintenance

or
Checking Engine Oil
Level
3000

NOTE: The snowmobile must be
on a level surface for this procedure.
CAUTION
The snowmobile will be manufactured
with the correct amount of oil in the
engine. If the engine and oil are not at
operating temperature the oil will not
read correctly on the oil level stick.
1. Start the engine and let it idle and
warm up until the fan on the radiator
turns on.
2. Shut the engine off; then remove the
left access panel. Remove the oil
level stick and wipe it with a clean
cloth.
3. Install the oil level stick and remove
the oil level stick; the engine oil
level should be within the operating
range but not above the FULL mark.
4. If step 1-3 was followed and the oil
level is not within the operating
range, add the recommended engine
oil through the oil stick tube. Install
the oil level stick and the left access
panel.
XM317A
SNO-525A