Pitney Bowes DM100i series Operator's Manual page 59

Changing the Lock Code and Password
Setting/Disabling the Lock Code
The Lock Code prevents unauthorised access to your mailing system
after the machine has entered sleep mode or it is in a "soft" power-
down mode (by pressing the Lock/Power key on upper right corner of
the control panel).
1. Press Options.
2. Press Page Down twice.
3. Select "LockCode/Passwords".
4. Select "Meter Lock Code". Enter a 4-digit code, this becomes
your lock code/ password. You are asked to confirm the code.
If there is an existing lock code, you are prompted to key in the
existing 4-digit code and then confirm the code.
5. When 'Meter lock code has been enabled' is displayed you can
then press Continue to return to the Options menu.
To either disable or enable the lock code (if previously used) or to
change the lock code.
1. Select "Meter Lock Code".
2. Select "Change Lock Code".
A. To disable the lock code:
Select "Disable Lock Code". At the confirmation message,
select "Continue".
B. To change or create a new lock code:
Select "Change Lock Code". At the prompt, type in a new
lock code (4 digits) and select "Continue". Re-enter the
new lock code again to confirm and select "Continue". At
the "Meter Lock Code has been enabled" message, select
"Continue".
3. Press Clear (back arrow key) twice to return to Options menu.
Your DM100i mailing machine contains postal funds and if
you opt to use the 4-digit Lock Code to secure the funds,
it is important that you do not allow your Lock Code to be
compromised if the machine is used in an open area. If you
believe your Lock Code has been compromised, it should be
changed immediately. Alternatively, you may wish to consider
locking the machine in a secure area.
SDC570G
IMPORTANT INFORMATION
6 • System Options
6-9