•
Do not remove covers or defeat safety interlock switches. Covers
enclose hazardous parts that should only be accessed by
properly trained service personnel. Immediately report to service
any damaged or non-functioning components that renders the
unit unsafe.
•
Place the unit in an accessible location to allow for proper
venting of the equipment and to facilitate servicing.
•
The power cord wall plug is the primary means of disconnecting
the machine from the AC supply.
•
Do not use an adapter plug on the line cord or wall outlet.
•
Do not remove the ground pin from the line cord.
•
Avoid using wall outlets that are controlled by wall switches, or
shared with other equipment.
•
Do not route the power cord over sharp edges or trap between
furniture.
•
Ensure there is no strain on the power cord and that it does not
become jammed between the equipment, walls or furniture.
•
Be certain the area in front of the wall receptacle into which the
machine is plugged is free from obstruction.
•
Before clearing a stoppage, be sure machine mechanisms come
to a stop.
•
When removing stalled material, avoid using too much force to
protect against minor personal injury and damaging equipment.
•
To prevent overheating, do not cover any vent openings.
•
Operation of this equipment without periodic maintenance will
inhibit optimum operating performance and could cause the
equipment to malfunction. Contact your machine supplier for
required service schedule.
•
Read all instructions before attempting to operate the equipment.
•
Use this equipment only for its intended purpose.
•
Always follow the specific occupational safety and health
standards for your workplace.
SDC570G
1 • Introduction
1-5