Table of Contents
Advertisement
Parameter
Enable Static Routing
Destination LAN IP
Subnet Mask
Default Gateway
Hop Count
Interface
Add a Rule
Remove a Rule
Click "Apply" at the bottom of the screen to save the above configurations. You
can now configure other sections or start using the router.
Description
Select to enable the function (it's disabled by default).
Enter the network address of the destination LAN.
Enter the subnet mask of the destination LAN.
Enter the next stop gateway of the path toward the
destination LAN. This is the IP of the neighbor router
that this router should communicate with on the path
to the destination LAN.
Enter the number of hops (routers) to pass through to
reach the destination LAN.
Select the interface that goes to the next hop (router).
Fill in the "Destination LAN IP," "Subnet Mask,"
"Default Gateway," "Hop Count" and "Interface" of the
rule to be added and click "Add." This rule will then be
added into the Static Routing Table below. To change
or correct an entry before adding it, click "Reset" to
clear the fields, then re-enter.
To remove some routing rules from the Static Routing
Table, select the rules in the table and click "Delete
Selected." To remove all rules from the table, click
"Delete All." Click "Reset" to clear current selections.
57
Advertisement
Table of Contents
