Table of Contents
Advertisement
Parameter
Mode
Band
ESSID
Channel Number
Associated Clients
WLAN MAC
Clone MAC
MAC address
Set Security
Click "Apply" at the bottom of the screen to save the above configurations. You
can now configure other advance sections or start using the router (with the
advanced settings in place).)
Default
Description
Select one of the six modes shown above.
Fix the AP at 802.11b or 802.11g mode, or
select the B+G mode to allow the AP to select
either 802.11b or 802.11g automatically.
Default
This is the name of the wireless LAN. All the
devices in the same wireless LAN should have
the same ESSID.
11
This is the channel used by the wireless LAN.
All devices in the same wireless LAN should
use the same channel.
Click "Show Active Clients" to display the
Active Wireless Client table, which shows the
status of all active wireless stations that are
connecting to the access point.
This is the MAC address used by the wireless
interface of this AP when it's in a station mode.
Click to copy the MAC address of your PC,
which you're using to configure the AP, to the
WLAN MAC.
To bridge more than one network together with
the wireless LAN, set this access point to "AP
Bridge–Point to Point," "AP Bridge–Point to
Multi-Point" or "AP Bridge–WDS." Then enter
the MAC addresses of other access points that
are joining the bridged network.
Click to display the WDS Security Settings
screen. Set the security parameters used to
bridge access points together when your AP is
in an AP Bridge mode (see Section 3.4.3).
38
Advertisement
Table of Contents
