To Power On The System For The First Time - Sun Oracle Sun Netra T5440 Installation Manual

compatability CLI as the default CLI (role=administrator, cli=alom). For more
information on using the ALOM compatability CLI, refer to the Integrated Lights Out
Manager 2.0 (ILOM 2.0) Supplement for Sun Netra T5440 Server.

▼ To Power On the System for the First Time

Caution – The serial terminal or a terminal emulator should be connected before
you connect the power cables, or you will not see the system messages. The server
goes into Standby mode and the ILOM service processor initializes as soon as the
AC/DC power cables are connected to the power source.
The service processor runs on the 3.3V standby voltage. As soon as AC/DC power is
connected to the system, the service processor powers on, runs diagnostics, and
initializes the ILOM firmware.
1. Connect a terminal or a terminal emulator (PC or workstation) to the service
processor serial management port.
Configure the terminal or terminal emulator with these settings:
9600 baud
■
8 bits
■
No parity
■
1 Stop bit
■
No handshake
■
Note – When you power on the server for the first time and you do not have a
terminal or terminal emulator (PC or workstation) connected to the service processor
serial management port, you will not see system messages. After connecting to the
server with a terminal or terminal emulator, log in to the ILOM CLI or the ALOM
compatability CLI to get to the service processor console.
2. Turn on the terminal or terminal emulator.
3. Connect the AC/DC power cables to Power Supply 0 and Power Supply 1.
Watch the terminal for system messages.
Chapter 5 Powering On the System 79