Track Tension And Alignment - Ski-Doo REV series 2007 Operator's Manual

– broken rods
– broken studs (studded tracks)
– bent studs (studded tracks)
– missing studs
– studs that are torn off the track
– missing track guide(s).
On Ice Series pre-studded tracks, broken or missing studs can not
be replaced.
On approved studded tracks, replace broken or damaged studs im-
mediately. If your track shows signs of deterioration, it must be re-
placed immediately. When in doubt, ask your dealer.
Riding with a damaged track or studs could lead to a loss of
control, resulting in a risk of serious injury or death.
For complete information on traction enhancing products, refer to the
section entitled TRACTION ENHANCING PRODUCTS in the SAFETY
INFORMATION section at the beginning of this Operator's Guide.

Track Tension and Alignment

NOTE: Track tension and alignment are interrelated. Do not adjust
one without the other.
To prevent serious injury to individuals near the snowmobile:
– NEVER stand behind or near a moving track
– always use a wide-base snowmobile stand with a rear de-
flector panel
– when the track is raised off the ground, only run it at the
lowest possible speed.
Centrifugal force could cause debris, damaged or loose studs,
pieces of torn track, or an entire severed track to be violently
thrown backwards out of the tunnel with tremendous force,
possibly resulting in the loss of a leg or other serious injury.
Tension
NOTE: Ride the snowmobile in snow about 15 to 20 minutes prior
to adjusting track tension.
Remove the tether cord cap.
_________________________
212
WARNING
WARNING