Do you have a question about the Grand Touring 700/SE and is the answer not in the manual?
Questions and answers
Lloyd Irwin Fell
March 13, 2025
how tight do I set the spring and bolt 31
1 comments:
Mr. Anderson
May 14, 2025
The recommended torque for the steering arm pinch bolt and nut is 23 N·m (17 lbf·ft). There is no information provided about a "spring and bolt 31," so the torque for that specific part cannot be determined.
This answer is automatically generated
Paul Hayes
February 21, 2025
The sled was running trailered it now wont start. Did turn over , but now nothing, The 2 20 Amp. fuses do not have power. What gives them power
1 comments:
Mr. Anderson
February 21, 2025
The MPEM (Multi-Purpose Electrical Module) controls the electricity supply to accessories. The lighting generator coil, which is a self-contained system, supplies current to the lighting system and other devices. However, for a 290 W system, the lighting generator coil is not part of the ignition system. If the sled won't start, the MPEM would typically provide power to the 20 Amp fuses.
This answer is automatically generated
tom
January 28, 2025
can i run my 97 700 grandtouring without dpm connected. and if so what do i disconnect, or block excample senors, line to carbs ect
1 comments:
Mr. Anderson
February 10, 2025
The DPM module must remain connected for proper operation. However, to test the system as if the engine temperature were -20°C (-4°F), you can disconnect the engine temperature sensor connector. If troubleshooting, do not disconnect both DPM connectors, as the compensation solenoid must remain plugged. If the DPM module fails, there will be no current on specific connectors, and the module should be replaced.
Need help?
Do you have a question about the Grand Touring 700/SE and is the answer not in the manual?
Questions and answers
how tight do I set the spring and bolt 31
The recommended torque for the steering arm pinch bolt and nut is 23 N·m (17 lbf·ft). There is no information provided about a "spring and bolt 31," so the torque for that specific part cannot be determined.
This answer is automatically generated
The sled was running trailered it now wont start. Did turn over , but now nothing, The 2 20 Amp. fuses do not have power. What gives them power
The MPEM (Multi-Purpose Electrical Module) controls the electricity supply to accessories. The lighting generator coil, which is a self-contained system, supplies current to the lighting system and other devices. However, for a 290 W system, the lighting generator coil is not part of the ignition system. If the sled won't start, the MPEM would typically provide power to the 20 Amp fuses.
This answer is automatically generated
can i run my 97 700 grandtouring without dpm connected. and if so what do i disconnect, or block excample senors, line to carbs ect
The DPM module must remain connected for proper operation. However, to test the system as if the engine temperature were -20°C (-4°F), you can disconnect the engine temperature sensor connector. If troubleshooting, do not disconnect both DPM connectors, as the compensation solenoid must remain plugged. If the DPM module fails, there will be no current on specific connectors, and the module should be replaced.
This answer is automatically generated