Ski-Doo REV series 2007 Operator's Manual page 75

DESS Status (DESS/RER)
This lamp will light up to confirm DESS status. Refer to DESS PILOT
LAMP CODES in TETHER CUT-OUT SWITCH for description.
Engine Management System (EMS)
This lamp will light up to indicate a trouble. Refer to ENGINE
MANAGEMENT SYSTEM (EMS) FAULTS in TROUBLESHOOTING
for trouble code meaning and remedy.
Engine Overheat Warning Lamp
If this lamp blinks (1 short and 1 long beep will also be heard), the
engine is overheating, reduce snowmobile speed and run snowmo-
bile in loose snow or stop engine immediately and allow engine to
cool. Check cooling system.
Mode Button
All Models
Depress mode button to change multifunction display. Each time en-
gine is started, display shows odometer. From that point depressing
mode button will change display for the trip meter.
Depressing mode button again will change display for the resetable
hourmeter. Push mode button again to return to odometer.
Push and hold mode button for 2 seconds to reset the tripmeter or
the resetable hourmeter depending on the one displayed.
Multifunction Display
All Models
Odometer
Odometer records the total distance travelled and displays it either
in miles or kilometers. Refer to UNIT SELECTION (MPH VS KM/H)
for changing units.
Trip Meter
Records distance travelled since it has been reset. Distance trav-
elled is displayed either in miles or kilometers. Refer to UNIT SE-
LECTION (MPH VS KM/H) for changing units.
Resetable Hourmeter
Records engine running time in hours and minutes since it has been
reset.
__________________________
73