Table of Contents
Advertisement
CAUTION
!
AVOID EQUIPMENT FAILURE!
IF OIL DOES NOT MOVE QUICKLY
THROUGH THE CLEAR TUBING
TOWARDS THE PUMP, TURN THE
SWITCH TO THE OFF POSITION,
ELEVATE THE CLEAR TUBING AS IT
NEARS THE ENTRANCE OF THE PUMP,
THEN FLIP THE SWITCH TO THE FILL
POSITION AGAIN.
This will lubricate the pump and insure a good starting
vacuum.
Run the engine to be drained until it reaches 140 degrees.
This will insure that the oil can be removed easily. Shut the
engine down and allow ample time for the recirculated oil
to return to the oil pan.
DRAINING THE PORT ENGINE
1. Warm engine to at least 140 degrees and turn the key
off.
2. Insert the PVC wand of the drain/fi ll hose into an
environmentally friendly waste container since you are
responsible for disposing of waste properly.
5. Flip the motor control switch to the "DRAIN" position.
The pump will start immediately. You should hear a
noticeable change in the sound (speed) of the pump motor
when the used oil enters the pump.
6. Continue to operate the pump until there is a noticeable
change in the sound (speed) of the pump motor, which
is an indication air is being drawn into the crankcase oil
hose and the crankcase is now empty. The oil drain rate is
about one gallon per 22 seconds.
7. Return the pump motor control switch to the "OFF"
position when the crankcase is empty and place the fail-
safe switch in the "OFF" position.
DRAINING THE STARBOARD ENGINE
1. Repeat each of the steps outlined in "Draining the Port
Engine" after switching the arrow-shaped tip on the valve
handle to the "STARBOARD ENGINE".
2. Flip the motor control switch to the "DRAIN"
position.
3. Once the crankcase is emptied, return the pump motor
control switch to the "OFF" position and place the fail-
safe switch to the "OFF" position.
DRAINING THE GENERATOR
1. Repeat each of the steps outlined in "Draining the Port
Engine" after switching the arrow-shaped tip on the valve
handle to the "GENERATOR ENGINE".
2. Flip the motor control switch to the "DRAIN"
position.
3. Once the crankcase is emptied, return the pump motor
control switch to the "OFF" position and place the fail-
safe switch in the "OFF" position.
42
Chapter 7
Advertisement
Table of Contents
