Table of Contents
Advertisement
Wash And Dry Automatically Procedure
If you want your load to go automatically from wash to
dry do the following:
• Follow the instructions for wash only and set the DRY
TIME knob (C) before pressing the ON/OFF button
(I).
• The Auto Dry lamp (M) will light to indicate the dry timer
has been set and at the end of the wash cycle, the appliance
will run the selected tumble drying cycle.
NOTICE
TO PROTECT DELICATE FABRICS,
THIS MACHINE WILL NOT ALLOW
A DRY PROGRAM TO BE SET
WHEN THE SILK
OR WOOL PROGRAM IS SELECTED.
NOTICE
TO OPTIMIZE THE PERFORMANCE
OF YOUR MACHINE
WHEN GOING FROM WASH
TO DRY AUTOMATICALLY,
ALWAYS USE FABRIC SOFTENER
DURING THE WASH CYCLE.
Auxiliary Equipment Operation
23
Notes: If the laundry load to be washed and dried is too
large to dry, then follow the instructions for wash only.
When the wash cycle has fi nished, you will need to remove
some of the items ( up to 50% ) after the wash cycle to
give the remaining laundry room to tumble freely while
drying.
Follow the instructions for dry only. Repeat this procedure
for the remainder of the load.
Notes: For your safety, the door stays engaged for the
duration of the dry cycle. However, should you need to
open the door during the drying cycle, two options are
available:
1. You can cancel the program by advancing the program
selector knob (A) to a "reset" position and waiting 5
seconds. Pilot lamp (L) will fl ash quickly, then slowly when
the door lock is released. Now turn the appliance off and
open the door.
2. Press the ON/OFF button (I) to turn the appliance off.
Wait 1-2 minutes for the door lock to release, then open
the door. When fi nished, close the door and press the ON/
OFF button again. The dry will automatically resume the
selected program where it left off.
WARNING
!
AVOID POSSIBLE FIRE!
CLEAN OUT THE LINT TRAP
AFTER EACH LOAD IN THE DRYER.
Advertisement
Table of Contents
