Setting Configuration Dip Switches - FLIR A3 F series User Manual

9 – Installation (FLIR A3xx pt series)
The camera supports RS-422 and RS-232 serial communications using common
protocols (Pelco D, Bosch).
NOTE: The terminal blocks for serial connections will accept a maximum 20 AWG wire size.
9.13

Setting configuration dip switches

The figure below shows the locations of dip switches SW102 and SW103
T639367;a2
Figure 9.5 FLIR A3xx pt series camera configuration
Pelco Address: This is the address of the system when configured as a Pelco device.
The available range of values is from decimal 0 to 255.
T639368;a1
Figure 9.6 Dip switch address/ID settings – SW102
Other serial communication parameters: The tables below defines the switch locations,
bit numbering and on/off settings.
27
Publ. No. T559743 Rev. a601 – ENGLISH (EN) – April 26, 2012