Differential Ring Signals; Answering Calls At Night - Vertical SUMMIT IP Phone User Manual

Differential Ring Signals

Differential Ring Signals
When multiple phones in a small area ring, it can be difficult to tell which are ringing. The
SUMMIT IP Phone has 15 Ring Tones available for differentiating one phone's ringing from
another. Four of the tones are stored in the phone permanent memory; the remaining ten
tones are in the system memory. Four of these ten can be downloaded into the phone
memory for use as the 5th to 8th Ring Tone.
iPECS IP Phones
To select the desired ring tone
1. Press the [TRANS/PGM] button.
2. Dial "1" for Ring Selection.
3. Dial "1" for Intercom or "2" for outside Line ring
4. Dial Ring Tone selection "1"-"8", the ring tone is received.
To download a Ring tone from the system to an iPECS IP Phone
1. Press the [TRANS/PGM] button.
2. Dial 1 for Ring selection.
3. Dial 5 for Ring tone download.
4. Dial the Ring tone storage bin "5"-"8".
5. Dial the Ring tone selection, "0"-"9", the tone is received.
6. Press the [HOLD/SAVE] button.
LDP Phones
To select the desired ring tone
1. Press the [TRANS/PGM] button.
2. Dial "1" for Ring Selection.
3. Dial "1" for Intercom or "2" for outside Line ring
4. Dial Ring Tone selection "1"-"15", the ring tone is received

Answering Calls at Night

In the Night mode, Loud Bell Control may be used to send ring signals to external bells. You
may answer these calls with Universal Night Answer (UNA).
To answer a call ringing during night mode:
1. Lift the handset,
2. Dial 567 (UNA code).
Release 1.0
IP Station User Guide
SUMMIT
Chapter 2: BASIC CALL HANDLING
.
2-11
April 2014