Forced Intercom Tone Ring; Hold, Common (System) & I-Hold Indication; Hold - Vertical Edge 120 User Manual

Forced Intercom Tone Ring

When you initiate an intercom call, you can use Forced Intercom Tone
Ringing to cause the called telephone to ring. After a Voice Announce
connection has been established to an extension, you may change the
alert signal at that extension from Voice Announce to Tone Ring.
Operation
1. Establish an intercom call to an extension in Voice Announce
mode (Hands-free or Private). Your telephone will display:
2. Press
Voice Announce to Tone Ringing. Your telephone will display:
3. A Tone Ringing alert signal is sent and continues at the called
extension until it is answered.
4. If your call remains unanswered, you may dial
to Voice Call Announce mode.
Hold, Common (System) & I-Hold Indication
You may place any outside line on System Hold by pressing the HOLD
button. When you place a line on System Hold, the green lamp for
that line will flash at the I-Hold rate. I-Hold Indication allows you to
distinguish easily between a call you placed on hold at your telephone
and calls placed on hold at other telephones. The green lamp
indicates that this is your holding line. The same system hold line will
flash the red lamp at all other extensions.
Operation
1. While on a line, the green lamp for that line is I-Use flashing
(double wink rate).
Press HOLD. The green lamp now flashes at a slow rate and the
2.
call is placed on System Hold.
NOTE
Also see Hold Key Lamp Indicators on page 36.
Edge 120 Digital Executive Telephone User Guide
VOICE CALL xx
msg
to change the alert signal at the called extension from
CALLING STA 10
cbck msg
again to return

HOLD

Page 23