Unitech HT630 User Manual page 29

Web Console Configuration
The Web Console is the most user-friendly method available to configure HT630. The following contents
introduce the Web Console function groups and function definitions.
The following topics are covered in this section:
λ
Configuring Your Browser
λ
System
Basic Setup
λ
Wireless Setup
Radio Settings
Security
λ
Management
Change Password
SNMP Setup
Upgrade Firmware
Backup/Restore Settings
Reboot AP
Note: You may use either a cross-over or straight-through Ethernet cable to connect HT630 to a PC, Hub, or
Switch. HT630's Ethernet port will auto-detect which type of cable is being used, and then adjust the signals
accordingly.
Configuring Your Browser
Before opening your browser, you need to enable cookies.
Attention: To use the Web Console, you will need to enable your browser for cookies. Your browser's
cookie options should be located on your browser's Internet Properties window. Since different
browsers , and different versions of the same browser are configured differently, refer to your
browser's help section for details.
1. Type 192.168.*.* (the IP address which get from DHCP or you set through HyperTerminal) in your
browser's Address box, and then press Enter.
2. Input the password if prompted. The password will be transmitted with MD5 encryption over the Ethernet.
Note that you will not be prompted to enter the password if the HT630 is not currently password
protected.
3. The HT630 homepage will open. On this page, you can see a brief description of the Web Console's four
function groups.
Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
25