Chapter 3 Operation; Ready Mode - Unitech HT630 User Manual

Hide thumbs Also See for HT630:

Table of Contents

The HT630 is set up several operating modes. The system of terminal may operate in various modes for

different purposes. The figure below shows the operating flow of the terminal. The following diagram

summarized these operating modes to switch between different modes.

System configurations are categorized in two groups, users can select "8.SET" command in User mode to set

general system configurations or enter Supervisor mode to set advanced system configurations. The

Supervisor mode is also protected with password checking to prevent unauthorized personnel from

changing the system configuration.

(For HT630 detail setup procedures please refer to HT630 Technical Binder). It is likely that your unit

came pre-configure by your software vender or system developer. In this case, please be caution when

changing these settings.

The terminal performs a Power-On-Test and Warm-Start when it is switched on. After the Warm Start, the

system enters Ready mode and shows the Ready mode prompt.

Ready mode

The first line indicates the model code and version number (e.g. V1.00). The second line

prompt

shows the size of the total installed RAM (i.e. 4608 KB). The third line prompts a ">" which

indicates that the terminal passed the Power-on-test and is ready to be used.

HT630 Vx.xx

MEM 4608 KB

Operation

Chapter 3

Table of Contents

Show Quick Links

Table of Contents