Unitech HT630 User Manual page 35
Hide thumbs
Also See for HT630:
- Reference manual (32 pages) ,
- Product reference manual (19 pages) ,
- Quick start manual (6 pages)
Table of Contents
Advertisement
In SNMP Setup you can enable and disable SNMP.
Read Community Name
When you Enable the SNMP, you should set the Read Community Name same as SNMP tool Setting.
Write Community Name
When you Enable the SNMP, you should set the Write Community Name same as SNMP tool Setting.
IP Address to Receive Traps
You can set a IP address, When SNMP tool change some setting, you can read some message from the
address.
Upgrade Firmware
1.
Open "Upgrade Firmware".
2.
Click "Browse" to select your wanted file for upgrade.
3.
Click "Upload" to enable the file to be loaded to your HT630.
4.
Reboot your HT630 and check whether the firmware has been upgraded in the Basic Information.
Backup / Restore Settings
HT630 provides backup and restore for file management.
Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
31
Hide quick links:
Advertisement
Table of Contents
