Memory Installation - SOLTEK SL-65MIV User Manual

3. Make sure that the CPU positions in the socket tightly, and then put the
lever down to complete the CPU installation.

2-2 MEMORY INSTALLATION

WARING !!!
• Make sure that you unplug your power supply when adding or removing
memory modules or other system components, failure to do so may cause
severe damage to both your motherboard and expansion cards.
• Be careful when inserting or removing DIMM, forcing a DIMM in or out of a
socket can be damaged the memory module or the socket. Some of DIMMs
contain EDO or FTP DRAM that accept only 5V power. These DIMM types
are incompliant with the motherboard, the M/B only supports 3.3V true
SDRAM DIMMs.
Installing DIMM:
• Make sure you have the correct memory module type for your motherboard.
• Insert the module(s) as shown, DIMMs have 168-pins and two notches that
will match with the onboard DIMM socket, memory modules are installed by
inserting them straight into the slot until they "click" into place. They only fit
in one direction so do not force them into place.
Removing:
• Press the holding clips on both sides of socket out ward to release the
DIMM, Gently pull the DIMM out of the socket.
168-Pin DIMM Notch Key Definitions(3.3V)
DRAM Key Position Voltage Key Position
Unbuffered
3.3V
65MIV/65MIV2/65MIV-X/65MIV2-X
17