Hdd/Fdd Installation - SOLTEK SL-65MIV User Manual

65MIV/65MIV2/65MIV-X/65MIV2-X

2-3 HDD/FDD INSTALLATION

• To install HDD (Hard Disk Drive), you may connect the cable's blue
connector to the motherboard's primary (IDE1) or secondary IDE
connector, and then connect the gray connector to your slave de-
vice and the black connector to your master device. If you install
two hard disks , you must configure the second drive to Slave mode
by setting its jumper accordingly. Please refer to your hard disk docu-
mentation for the jumper settings.
• To install FDD (Floppy Disk Drive), you may connect the single end
to the board , and connect two plugs on the other end to the floopy
drives.
ON
1 2 3 4 5 6 7 8
JFAN2
AC'97
Codec
1 4
JCD1
JCD2
1 3
WOL1
JP9
1 4
18
RT1
VIA
VT8605
SW1
DIP
AGP 4X
PCI 1
JBAT1
1 3
PCI 2
VIA RT2
VT82C
686A
PCI 3
Floppy Disk Drive Connector:
Orient the red markings on
the floppy ribbon cable to
Pin1.
Hard Disk Drive Connector:
Orient the red markings on
the IDE ribbon cable to Pin1.