Engine Does Not Start
ENGINE DOES NOT TURN OVER
1. Scrolling safety message on the multifunction gauge not acknowledged.
– Read the safety message then press the MODE button.
2. Engine stop switch in the OFF position.
– Make sure that the engine stop switch is in the ON position.
3. Clutch lever not engaged (SM5 model).
– Pull in and hold the clutch lever.
4. Ignition switch in the OFF position.
– Turn the ignition to the ON position.
5. Battery dead or poor battery connections.
– Check the battery charge. Recharge if necessary (p. 130).
– Check the battery connections under the seat and on the battery terminals
(p. 130).
6. Blown fuse.
– Check fuse condition (p. 139).
7. Transmission is in gear (SE5 model).
– Depress brake pedal if transmission is in gear.
ENGINE TURNS OVER, BUT DOES NOT START
1. Low fuel.
– Fill the fuel tank. Refer to (FUELING (p. 45)).
2. Weak battery.
– Check battery charge. Recharge if necessary (p. 130).
– Check the battery connections under the seat and on the battery terminals
(p. 130).
3. Engine management problem.
– Check to see whether the engine indicator lamp is ON while starting. See an
authorized Can-Am roadster dealer.
______________
PROBLEMS
147