Electrical Accessories Failure - Can-Am Spyder RT Operator's Manual

14. Have the battery fully recharged
with a battery charger (p. 130) or
by a qualified service station as
soon as possible.
If the engine dies shortly after it has
been jump started or when the jumper
cables are disconnected, there might
be a problem with the charging sys-
tem. Have the vehicle transported
(p. 106) and repaired by the nearest au-
thorized Can-Am roadster dealer.
After recharging battery, have the vehi-
cle inspected by an authorized Can-Am
roadster dealer.
Electrical Accessories
Failure
If any electrical accessories stop work-
ing on the vehicle, check for blown
fuses and replace if necessary.
If an electrical failure still occurs, have
the vehicle serviced by an authorized
Can-Am roadster dealer.
Fuses
Fuse Locations
Fuses are located:
– In the front storage compartment.
– Under the seat on the right side of
the vehicle.
rmo2010-008-004_a
TYPICAL
1. Fuse box in front storage compartment
rmo2010-001-013_a
1. Fuse box located under the seat
Fuse Description
rmo2010-001-109_a
FUSES LOCATED IN FRONT STORAGE
COMPARTMENT
NO. DESCRIPTION
Lights: tail, position, plate & day
1
Vbat: Cluster, VIM & DLC
Vbat Control: main relays
2 Vkey: SAS, YRS, VCM, ECM,
D.E.S.S., PRS & MSR
Vbat: Main relay
3
Vrelayed: WPM, CL, FG, CTG, PBS
pilot light, TCM, DPS
4 Vbat: Cooling fan relay
5 Vbat: Hazard, brake light switch
6 Vbat: radio (XM, CB, GPS, "iPod")
Vbat: Backup actuator & trailer
7
module
______________
PROBLEMS
RATING
15 A
10 A
25 A
15 A
10 A
15 A
10 A
139