Gearshift Selector (Se5 Model); Brake Pedal - Can-Am Spyder RT Operator's Manual

Lift up or press down fully to move se-
quentially from one gear to the next.
When the lever is released, it returns
to center where the mechanism resets
for the next shift up or down. Neutral
(N) is selected by either a half lift from
first gear or a half press from second
8) SHIFTING (p.67)
gear. Refer to
detailed instructions.
To shift into reverse, refer to
ATING IN REVERSE (p.70)
instructions.
5) Gearshift Selector
(SE5 Model)
The gearshift selector is below the left
handgrip.
rmo2010-001-035_a
1. Gearshift selector
Press selector forward to upshift. Pull
selector toward you to downshift.
rmo2010-001-036_a
1. Upshift
2. Downshift
This shifts sequentially from one gear
to the next. Release the selector after
shifting.
To shift through multiple gears, use the
selector multiple times.
To shift into neutral from first gear or
reverse, briefly press or pull the gear
for
selector. A longer activation will shift
over neutral. Refer to
10) OPER-
(p.75)
for detailed instructions.
for detailed
When the gearshift selector is re-
leased, the mechanism resets for the
next shift up or down.
If operator does not downshift when
slowing down and engine RPM drops
below a threshold value, the gearbox
will automatically downshift to the
next available gear.
If the engine is started with gearbox in
gear, it will automatically shift to neu-
tral position.
NOTE: When a trailer is towed, the
trailer mode must be activated to adapt
the gear changes. Refer to
THE TRAILER MODE (p.90)
NOTICE
activated when towing a trailer, en-
gine components might be dam-
aged.

6) Brake Pedal

The brake pedal is in front of the right
footrest. Press it down to operate.
This pedal brakes all three wheels.
rmo2010-001-037_a
1. Brake pedal
2. Footpeg
_______________
PRIMARY CONTROLS
7) SHIFTING
SETTING
.
If the trailer mode is not
13