Hcm Oil Filter (Se5 Model); Air Filter - Can-Am Spyder RT Operator's Manual

MAINTENANCE PROCEDURES
rmr2008-011-005_a
1. Apply oil here

HCM Oil Filter (SE5 Model)

NOTE: The HCM (Hydraulic Control
Module) uses the same oil as the en-
gine, but has its own oil filter.
HCM Oil Filter Removal
Refer to MAINTENANCE SCHEDULE
(p.110)
for replacement frequency.
1. Drain engine oil. Refer to
OIL CHANGE (p.123)
section.
2. Remove oil filter cover screws.
rmr2008-078-013_a
1. Oil filter cover
2. Cover screws
3. Remove oil filter cover with O-ring.
Discard O-ring.
4. Remove oil filter.
5. Dispose filter as per your local envi-
ronmental regulations.
______________
126
HCM Oil Filter Installation
The installation is the reverse of the re-
moval procedure. Pay attention to the
following.
1. Check and clean the oil inlet and out-
let orifices in hydraulic control mod-
ule for dirt and contaminations.
rmr2008-077-003_a
1. Oil outlet orifice to the hydraulic control
module lubrication system
ENGINE
2. Oil inlet orifice to the oil pump
2. Install a NEW O-ring on oil filter
cover.
To ease assembly and prevent dis-
placement of the O-ring during instal-
lation, slightly oil filter and O-ring, refer
to following illustration.
rmr2008-077-004_a
1. Apply oil here

Air Filter

Air Filter Removal
1. Remove the right middle side panel.
2. Remove the right top side panel.
3. Remove the right acoustic panel.
4. Remove both screws on the right
side of the acoustic panel.