Hantek 1060 User Manual page 79

Figure 4-9 AC Current Measurement for 600 mA
3) Press the F1 key once and AC will display on the bottom of the screen.
4) Insert the black lead into the COM banana jack input and the red lead into the 10A
banana jack input.
5) Connect the red and black leads to the measured point and the AC current value of
the measured point will be displayed on the screen.
6) Press F2 to return to 600 mA measurement.
Then, the screen will look like the following figure 4-10.
Figure 4-10 AC Current Measurement for 10A
Taking a Relative Measurement
A currently measured result relative to the defined reference value is displayed in a rela-
tive measurement.
The following example shows how to take a relative measurement. At first, it is required
to acquire a reference value.
1) Press the R key.
2) Insert the black lead into the COM banana jack input and the red lead into the V/Ω/C
banana jack input.
3) Connect the red and black test leads to the resistor. The resistor value is shown on
the screen in Ohm.
4) When the reading leveling off, press F1 key and then ||/ ,is displayed on the top of