Hantek 1060 User Manual page 62

Do as the following steps:
1. Select menu Mode->Manual.
2. Select menu Type->X/Y to get the vertical or horizontal of Cursor A or Cursor B.
3. Select menu Source->CH1/CH2/MATH to Get the Cursor Source.
4. Select Cursor A or Cursor B to adjust the increments between Cursor A and Cursor B.
5. Get the values between Cursor A and Cursor B.
delt x is the time between Cursor A and Cursor B.
1/delt x is the frequency between Cursor A and Cursor B.
3. Track Cursor Mode
In Track Cursor Mode, the Cursor A and Cursor B move together with the selected
waveform. See figure 2-63.
Please do the following steps:
1. Select menu Mode->Track.
2. Select Source for measurements. Select options as followings.
Cursor A->CH1/CH2. Cursor B->CH1/CH2.
3. Select Cursor A or Cursor B. Move the Select Cursors to adjust the increments
between the Cursors.
4. Get the values between Cursor A and Cursor B.
delt x is the time between Cursor A and Cursor B.1/delt x is the frequency between
Cursor A and Cursor B.delt y is the voltage between the Cursor A and Cursor B.
Figure 2-62 The Manual Cursor Mode
Figure 2-63 Track Cursor Mode
60