Hantek 1060 User Manual page 24

Figure 2-5 Waveform Display
3. Set Probe Attenuation
The scope meter allows adjusting the probe attenuation scale factor correspondingly
in the channel operation menu in order to comply with the probe attenuation scale.
The attenuation factor changes the vertical scaling of the scope meter so that the
measurement results reflect the actual voltage levels at the probe tip.
To change (or check) the probe attenuation setting, press the CH1 or CH2 button
(according to which channel in using). Toggle the Probe soft button to match the
attenuation factor of the probe.
This setting remains in effect until changes again.
Figure 2-6 Probe Setting
4. Invert a waveform
The displayed waveform reverses 180 degrees relatively to the ground potential.
CH1 or CH2 → F5 → F3 Invert
Press , to turn on/off the
22