Hantek 1060 User Manual page 21

Menu Setting
Enable
Coupling
Probe
1000X
Reset
1/2
2/2
Coarse
Volt/Div
Invert
BW Limit
2/2
1. Change Volt/DIV
It is the default setting of Volts/Div in a 1-2-5-step sequence from 10mV/div, 20mV/div,
50mV/div, to 1V/div,5 V/div or 10V/div.
The Volt/DIV will be displayed in the status bar on the bottom of the screen
Press CH1→Volt/Div→Coarse/Fine to Set Volt range.
ON Turn on Channel
OFF Turn off Channel
AC The dc component in the input signal is blocked
DC The ac and dc components of the input signal are allowed
GND Disconnect the input signal
1X Select one according to the probe attenuation factor to
10X ensure correct vertical scale reading
100X
Set the vertical display position back to middle window
Go to the next menu page
Back to the previous menu page
Set Voltage range coarsely
Fine Set Voltage range finely
ON Turn on the invert function
OFF Turn off the invert function
ON Turn on the BW Limit
OFF Turn off the BW Limit
Back to the previous menu page
Figure 2-2 Channel Volt/Div
Description