Hantek 1060 User Manual page 60

Type
Source
Cursor A
Cursor B
The scope meter measures the Y or X coordinate values of the cursors, and the
increments between the two cursors.
To do cursor measurements, please do as the following steps:
1. Turn on the cursor measurement:
Cursor→Mode→Manual / Track / Auto.
2. Select channel Source for measurements by pressing soft button as:
Cursor→Source→CH1 / CH2 / MATH.
3. Select the cursors type by pressing soft button as Cursor→Type→ X or Y.
4. Press F4 or F5 to select the Cursor A or Cursor B.
5. Move the cursors to adjust the increment between the cursors.
The values will be automatically displayed on the right upper corner of screen when the
cursor function menu is hidden or displaying other menus.
Comments of Cursor Measurements
1. Auto Cursor Mode
The Auto Cursor Mode displays the cursors for the current measuring automatically. See
figure 2-61.
2. Manual Cursor Mode
In this mode, the scope meter measures the Y or X coordinate increments between the
two cursors. See figure 2-62.
1) Select menu Mode->Manual.
2) Select menu Type->X/Y to get the vertical or horizontal of Cursor A or Cursor B.
3) Select menu Source->CH1/CH2/MATH to Get the Cursor Source.
4 )Select Cursor A or Cursor B to adjust the increments between Cursor A and Cursor B.
5) Get the values between Cursor A and Cursor B.
delt x is the time between Cursor A and Cursor B.
1/delt x is the frequency between Cursor A and Cursor B.
3. Track Cursor Mode
In Track Cursor Mode, the Cursor A and Cursor B move together with the selected
waveform. See figure 2-63.
Shown as vertical line to measure the horizontal
X
parameters.
Shown as horizontal line to measure the vertical
Y
parameters.
CH1
CH2 Select the measurement signal source.
MATH
Select Cursor A or not
Select Cursor B or not
5