Hantek 1060 User Manual page 51

Pass/Fail
The Pass/Fail function monitors changes of signals and output pass or fail signals by
comparing the input signal is within the pre-defined mask.
Utility→Pass/Fail
Press
The Pass/Fail menu (Page 1/2)
The Pass/Fail menu (Page 2/2)
The Pass/Fail menu table (Page 1/2)
Menu
Enable
Source
Output
Fail+Beep
Pass +Beep
Operate
1/2
The Pass/Fail menu table (Page 2/2)
Menu Setting
2/2
to go to the following menu.
Figure 2-45 The Pass/Fail menu
Figure 2-46 The Pass/Fail menu
Setting
ON Turn on Pass/Fail test
OFF Turn off Pass/Fail test
CH1 Select Pass/Fail test on CH1
CH2 Select Pass/Fail test on CH2
Fail Output when Fail condition detected
Pass Output when Pass condition detected
Output and Beep when Fail condition detected
Output and Beep when Pass condition detected
Stop Pass/Fail test stopped, press to run
Start Pass/Fail test running, press to stop
Go to the next menu page
Back to the previous menu page
Description
Description