CHAPTER 2: Operating Scope
The end user should know how to determine the system setup from the status bar of a
Scope Meter. This chapter will detail the scope meter function of the test tool.
■
Set Vertical System
■
Set Horizontal System
■
Set Trigger System
■
Save and Recall waveforms and setups
■
Utility Function
■
Measure Signal
■
Cursor Measure
Set Vertical System
Each channel of Scope meter has its own independent operation menu and it will pop up
after pressing CH1 or CH2 button. The settings of all items in the menu are shown in the
table below.
To make vertical CH1 and CH2 settings, do the following:
1. Press the CH1 or CH2 button and then the function menu appears at the bottom of
the screen.
2. Select and press key from F1 to F5 keys to make different settings.
Now, you can find the menu that looks like the following figure 2-1.
The CH1 menu (Page 1/2)
The CH1 menu (Page 2/2)
The following table describes the channel menu:
Figure 2-1
The CH1 Menu