Measuring Resistance Values; Making A Diode Measurement - Hantek 1060 User Manual

3)The symbol of Mutimeter current mode
4) Manual/Auto range indictors, among which the MANUAL refers to measuring range
in manual operation mode and Auto means the measuring range in automatic
operation mode.
5) The reading value of measurement.
6) The bar graph indictor.
7) DC or AC Measurement mode control.
8) Absolute /relative magnitude measuring control: The sign "||" expresses the absolute
magnitude measuring control and "
control.
9) Manually or automatically measuring range control.
Operating the Multimeter
If you are in the scope mode window, press DMM/OSC key, the scope meter will switch
to the multimeter mode window.Then the screen will display the measure mode window
that was in use the last time before you quit multimeter measure. When you switch to the
multimeter measurement the first time, the default measure mode is DC voltage mode.

Measuring Resistance Values

To measure a resistance, do the following:
1) Press the R key and then resistance measurement window appears on the screen.
2) Insert the black lead into the COM banana jack input and the red lead into the V/Ω/C
banana jack input.
3) Connect the red and black test leads to the resistor. The resistor value value is shown
on the screen in Ohm.
Then, the screen will look like the following figure 4-2.

Making a Diode Measurement

To make a measurement on the diode, do the following:
1) Press the diode key and a diode symbol appears at the top of the screen.
2) Insert the black lead into the COM banana jack input and the red lead into the V/Ω/C
banana jack input.
3) Connect the red and black leads to the diode and the voltage value of the diode is
displayed on the screen in voltage value.
Then, the screen will look like the following figure 4-3.
" represents the relative magnitude measuring
0
.