Making A Capacitance Measurement - Hantek 1060 User Manual

Making On-off Test
To perform an On-off test, do the following:
1) Press the On-off key and then On-off indictor appears on the top of the screen.
2) Insert the black lead into the COM banana jack input and the red lead into the V/Ω/C
banana jack input.
3) Connect the red and black leads to the test point. If the resistance value of the tested
point is less than 30 Ω, you will hear beep sound from the test tool.
Then, the screen will look like the following figure 4-4.

Making a Capacitance Measurement

To measure a capacitance, do the following:
1) Press the C key and a capacitor symbol appears on the top of the screen.
2) Insert the black lead into the COM banana jack input and the red lead into the V/Ω/C
banana jack input.
3) Connect the red and black leads to the capacitor and the capacitance value is displayed
on the screen in μF or nF.
Then, the screen will look like the following figure 4-5
Figure 4-4: On-off Measurement
figure 4-4
2