Hantek 1060 User Manual page 39

Sweep
HF
Reject
Pulse Trigger Setting
Pulse trigger occurs according to the width of pulse. The abnormal signals can be
detected through setting up the pulse width condition.
Press TRIG → F1 → Pulse button to show the pulse trigger menu as the following table.
The Pulse Trigger Menu (Page 1/2)
The Pulse Trigger Menu (Page 2/2)
Menu
Source
When
Setting
1/2
Auto Acquire waveform even no trigger occurred
Normal Acquire waveform when trigger occurred
Single When trigger occurs, acquire one waveform then stop
ON
Reject high frequency signals
OFF
Figure 2-27 The Pulse Trigger Menu
Figure 2-28 The Pulse Menu
The Pulse Trigger Table (Page 1/2)
Setting
CH1 Define CH1 or CH2 as trigger signal
CH2
+more +Pulse width more than
+Less +Pulse width less than
+Equal +Pulse width equal to
-more -Pulse width more than
-Less -Pulse width less than
-Equal -Pulse width equal toTo select pulse condition.
Value Set required pulse width.
Go to the next menu page
Description