Point-To-Multipoint Bridging - Cisco Aironet 1540 Series Hardware Installation Manual

Network Deployment Examples
Wireless client access is supported; however, if bridging between tall buildings, the 2.4-GHz wireless
coverage area may be limited and possibly not suitable for direct wireless client access.
Figure 1-5

Point-to-Multipoint Bridging

The access points can be used as a RAP to connect multiple remote MAPs with their associated wired
networks. By default this capability is turned-off for all access points. To support Ethernet bridging, you
must enable bridging on the controller for each access point. Wireless client access can be provided over
the bridging link; however, if bridging between tall buildings, the 2.4-GHz wireless coverage area may
be limited and possibly not suitable for direct wireless client access.
of access point-to-multipoint bridging.
Figure 1-6
Cisco Aironet 1540 Series Outdoor Access Point Hardware Installation Guide
1-8
Access Point Point-to-Point Bridging Example
(5 GHz)
Access Point to Multipoint Bridging Example
(5 GHz)
(5 GHz)
Chapter 1 Overview
Figure 1-6 illustrates an example