Rs-232 Host Parameters - Motorola LI4278 Product Reference Manual

7 - 4 LI4278 Product Reference Guide

RS-232 Host Parameters

Various RS-232 hosts are set up with their own parameter default settings
Fujitsu, Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, Olivetti, Omron, or terminal sets the defaults listed
below.
Terminal Specific RS-232
Table 7-2
Parameter
Yes
Transmit Code ID
Data/Suffix
Data Transmission
Format
CR (1013)
Suffix
9600
Baud Rate
Even
Parity
RTS/CTS
Hardware
Option 3
Handshaking
None
Software
Handshaking
9.9 Sec.
Serial Response
Time-out
One
Stop Bit Select
8-Bit
ASCII Format
Disable
Beep On <BEL>
High
RTS Line State
None
Prefix
In the Nixdorf Mode B, if CTS is low, scanning is disabled. When CTS is high, scanning is enabled.
If you scan Nixdorf Mode B without connecting the linear imager scanner to the proper host, it may
appear unable to scan. If this happens, scan a different RS-232 host type within 5 seconds of cycling
power to the linear imager scanner.
The CUTE host disables all parameter scanning, including Set Defaults. If you inadvertently select CUTE,
scan *Enable Parameter Bar Code Scanning (01h) on page 5-5, then change the host selection.
Wincor-
ICL Fujitsu Nixdorf
Mode A
Yes Yes
Data/Suffix Data/Suffix
CR (1013) CR (1013)
9600 9600
None Odd
None RTS/CTS
Option 3
None None
2 Sec. 9.9 Sec.
One One
8-Bit 8-Bit
Disable Disable
Low Low
None None
(Table
Wincor-
Nixdorf Mode Olivetti
B/OPOS/JPOS
Yes Yes
Data/Suffix Prefix/Data/
Suffix
CR (1013) ETX (1002)
9600 9600
Odd Even
RTS/CTS None
Option 3
None ACK/NAK
9.9 Sec. 9.9 Sec.
One One
8-Bit 7-Bit
Disable Disable
Low = No data to Low
send
None STX (1003)
7-2). Selecting the ICL,
Omron CUTE
Yes Yes
Data/Suffix Prefix/Data/
Suffix
CR (1013) CR (1013)
ETX (1003)
9600 9600
None Even
None None
None None
9.9 Sec. 9.9 Sec.
One One
8-Bit 7-Bit
Disable Disable
High High
None STX (1002)