Auto-Reconnect In Bluetooth Keyboard Emulation (Hid Slave) Mode - Motorola LI4278 Product Reference Manual

4 - 18 LI4278 Product Reference Guide

Auto-reconnect in Bluetooth Keyboard Emulation (HID Slave) Mode

Parameter # 604
In Bluetooth Keyboard Emulation (HID Slave) mode, select a re-connect option for when the linear imager
scanner loses its connection with a remote device:
Auto-reconnect on Bar Code Data: The linear imager scanner auto-reconnects when you scan a bar
•
code. With this option, a delay can occur when transmitting the first characters. The linear imager
scanner sounds a decode beep upon bar code scan, followed by a connection, a page timeout, a
rejection beep, or a transmission error beep. Select this option to optimize battery life on the linear
imager scanner and mobile device. Note that auto-reconnect does not occur on rejection and cable
unplug commands.
Auto-reconnect Immediately: When the linear imager scanner loses connection, it attempts to
•
reconnect. If a page timeout occurs, the linear imager scanner attempts reconnect on a trigger pull.
Select this option if the linear imager scanner's battery life is not an issue and you do not want a delay to
occur when the first bar code is transmitted. Note that auto-reconnect does not occur on rejection and
cable unplug commands.
Disable Auto-reconnect: When the linear imager scanner loses connection, you must re-establish it
•
manually.
*
Auto-reconnect on Bar Code Data
Disable Auto-reconnect
(1)
(0)
Auto-reconnect Immediately
(2)