Various RS-232 hosts are set up with their own parameter default settings
A, Wincor-Nixdorf Mode B, Olivetti, Omron, or terminal sets the defaults listed below.
Parameter
Transmit Code ID
Data Transmission Format
Suffix
Baud Rate
Parity
Hardware Handshaking
Software Handshaking
Serial Response Time-out
Stop Bit Select
ASCII Format
Beep On <BEL>
RTS Line State
Prefix
*In the Nixdorf Mode B, if CTS is Low, scanning is disabled. When CTS is High, the user can scan bar codes.
**If Nixdorf Mode B is scanned without the cradle connected to the proper host, the scanner may appear unable to scan. If this happens, scan a different
RS-232 host type within 5 seconds of cycling power to the cradle.
Table 7-2. Terminal Specific RS-232
Standard
(Default)
ICL
Fujitsu
No
Yes
Yes
Data as is
Data/Suffix
Data/Suffix
CR/LF (7013) CR (1013)
CR (1013)
9600
9600
9600
None
Even
None
None
RTS/CTS
None
Option 3
None
None
None
2 sec.
9.9 sec.
2 sec.
One
One
One
8-Bit
8-Bit
8-Bit
Disable
Disable
Disable
Low
High
Low
None
None
None
(Table
7-2). Selecting the ICL, Fujitsu, Wincor-Nixdorf Mode