Rs-232 Host Parameters - Motorola symbol ds9808 Reference Manual

7 - 4 Symbol DS9808 Product Reference Guide

RS-232 Host Parameters

Various RS-232 hosts use their own parameter default settings. Selecting standard, ICL, Fujitsu, Wincor-Nixdorf
Mode A, Wincor-Nixdorf Mode B, OPOS/JPOS, Olivetti, or Omron sets the defaults listed in
Terminal Specific RS-232
Table 7-2
Parameter
Transmit Code ID Yes
Data Transmission Data/Suffix
Format
Suffix CR (1013)
Baud Rate 9600
Parity Even
Hardware RTS/CTS
Handshaking Option 3
Software None
Handshaking
Serial Response 9.9 Sec.
Time-out
Stop Bit Select One
ASCII Format 8-Bit
Beep On <BEL> Disable
RTS Line State High
Prefix None
*In the Nixdorf Mode B, if CTS is low, scanning is disabled. When CTS is high, scanning is enabled.
** If you scan Nixdorf Mode B without connecting the digital scanner to the proper host, it may appear
unable to scan. If this happens, scan a different RS-232 host type within 5 seconds of cycling power to the
digital scanner.
ICL Fujitsu
Yes Yes
Data/Suffix Data/Suffix
CR (1013) CR (1013)
9600 9600
None Odd
None RTS/CTS
Option 3
None None
2 Sec. 9.9 Sec.
One One
8-Bit 8-Bit
Disable Disable
Low Low
None None
Wincor- Wincor-
Nixdorf Nixdorf Mode
Mode A B/OPOS/JPOS
Yes
Data/Suffix
CR (1013)
9600
Odd
RTS/CTS
Option 3
None
9.9 Sec.
One
8-Bit
Disable
Low = No data
to send
None
Table 7-2.
Olivetti Omron
Yes Yes
Prefix/Data/ Data/Suffix
Suffix
ETX (1002) CR (1013)
9600 9600
Even None
None None
Ack/Nak None
9.9 Sec. 9.9 Sec.
One One
7-Bit 8-Bit
Disable Disable
Low High
STX (1003) None