Motorola LI4278 Product Reference Manual page 48

2 - 2 LI4278 Product Reference Guide
Scanner Beeper and LED Definitions (Continued)
Table 2-1
Beeper Sequence
Four long low beeps
Four short high beeps
Five long low beeps
Long low/long high/long
low/long high beeps
Wireless Operation
Low beep
Long low/long high/long
low/long high beeps
High/low/high/low beeps
Low/high beeps
High/low beeps
Long low/long high beeps
Five high beeps
(only when configured)
LED Indication
Red
None
Red
Red
None
Red
None
None
None
Red
Green Blinking
Indication
1. A transmission error was detected in a scanned
symbol. The data is ignored. This occurs if a unit is not
properly configured. Check option setting.
2. When communicating with a cradle, the cradle
acknowledges receipt of data. If the acknowledgment is
not received, this transmission error beep sequence
sounds. Data may still have been received by the host.
Check the host system for receipt of transmitted data. If
data was not received by the host, re-scan the bar code.
Low battery warning.
Conversion or format error.
Out of memory - unable to store a new bar code.
Linear imager scanner detects power when inserted into
a cradle.
Note: This feature is enabled by default and can be
disabled (see
Beep on Insertion on page 4-19).
Cradle is out of batch storage memory, unable to store
new bar code.
Pairing bar code scanned.
Bluetooth connection established.
Bluetooth disconnection event.
Note: When connected to a remote device using SPP or
HID, if a disconnect beep sequence sounds immediately
after a bar code is scanned, check the host device for
receipt of transmitted data. It is possible that an attempt
was made to transmit the last bar code scanned after
the connection was lost.
Page timeout; remote device is out of range/not
powered. (See
Auto-reconnect Feature on page
1. Bluetooth attempting reconnection.
2. Emitted every 5 seconds while a reconnection
attempt is in progress. (See
Feature on page 4-14.)
4-14.)
Auto-reconnect